If you’ve read anything about soil in Carlsbad, you may have seen that expansive soil is a low concern here. That’s true in a specific sense, and it’s worth knowing exactly what sense. A citywide rating is a planning tool. It isn’t a test of the dirt under your slab, and it can’t tell you why one corner of your living room has a crack the rest of the house doesn’t.
This note walks through what the rating says, word by word, and what kind of evidence actually answers the question for a single lot.
Where the “low” comes from
The source is the City of Carlsbad’s annex to the 2023 San Diego County Multi-Jurisdictional Hazard Mitigation Plan. Section 5 of the annex scores each hazard on four columns: how much of the city’s area is affected, the maximum probable extent, the probability of future events, and an overall significance ranking.
For expansive soils, the scores are:
- Location: Negligible
- Maximum probable extent: Weak
- Probability of future events: Unlikely
- Overall significance: Low
A separate table in the annex describes the hazard plainly. Expansive soils shrink when dry and swell when wet, and that movement can push hard enough to crack sidewalks, driveways, basement floors, pipelines and even foundations. For Carlsbad specifically, the annex says it “presents a minor threat to limited portions of the city.”
Read that last phrase twice. Minor threat. Limited portions. It doesn’t say no portions. The annex is ranking hazards against each other to decide where the City puts planning effort, and by that yardstick expansive soil sits well below wildfire, earthquake and flooding. That’s useful context. It’s also a statement about the city as a whole, not about any one pad.
What counts as expansive in the building code
The California Building Code takes a very different approach. It doesn’t care about citywide averages. It defines expansive soil by laboratory tests on samples from the site.
Section 1803.5.3 of the 2025 code says soil is considered expansive when it meets four conditions: a plasticity index of 15 or more, more than 10 percent of particles passing a No. 200 sieve, more than 10 percent of particles finer than five micrometers, and an expansion index above 20 under the ASTM D4829 test. The code allows the first three tests to be skipped if the expansion index test is run. In practice, that expansion index number is what most soils reports lead with.
The same section tells the building official to require soil tests in areas likely to have expansive soil. Section 1803.5.2 goes further: where the classification, strength or moisture sensitivity of the soil is in doubt, the official can require a geotechnical investigation. The point is that the code expects lot-level evidence whenever there’s a real question. A planning rating doesn’t replace it.
Subdivisions already went through this once
Much of Carlsbad was built as subdivisions, and California has long required soils work at that scale. The building code carries the state housing department’s summary of the Health and Safety Code rules. A city must require a preliminary soil report from a registered civil engineer for every subdivision that needs a tentative and final map. If that report shows critically expansive soils or similar problems, a soil investigation of each lot is required, with recommendations meant to prevent structural damage. Once approved, those recommendations become conditions of the building permit.
That history matters for you as an owner. If your home is part of a tract, a soils report or grading report may exist for the subdivision, and sometimes for individual lots. Those documents often describe the fill, the native soil and any expansive layers the engineer found when the pads were built. They’re the closest thing to a test of your ground that you can get without drilling. Our post on finding original building plans covers where to look.
Why “low” and “my crack” can both be true
A low citywide rating and real seasonal movement at one house aren’t a contradiction. A few reasons that happens:
- Fill varies. Graded pads mix cut and fill. One end of a house can sit on a different material than the other.
- Moisture isn’t uniform. A planter against the foundation, a leaking irrigation line or a downspout that dumps at the corner will wet the soil on one side only. Even modestly expansive soil reacts to that.
- Small numbers still move. The code’s threshold is an expansion index above 20. Soil near that line can still shift enough to stick a door or open a hairline crack in a dry fall followed by a wet winter.
That pattern, movement that comes and goes with the seasons, is a clue worth tracking. Our post on sticking doors and seasonal movement goes into how to log it. If water is the trigger, our downspout and pad drainage note is the next read.
What a lot-level answer looks like
When the question is real, a geotechnical engineer answers it. Under Section 1803.6 of the building code, a geotechnical report includes recommendations for foundation type and design criteria, including provisions to mitigate expansive soil where it’s present. The investigation itself rests on borings or test pits and lab testing, as Section 1803.2 describes.
Not every crack needs that. Many don’t. The sensible order is to look first, gather what already exists and test only if the evidence points that way:
- Pull any subdivision soils, grading or compaction reports you can find.
- Map the cracks and sticking doors, with dates, through at least one wet and one dry season.
- Check drainage and irrigation near the foundation.
- Bring that record to a structural evaluation before deciding on testing.
Any digging near footings has its own rules. Section 1804 of the building code says excavation can’t remove support from an existing foundation without underpinning or protection, which is one reason root barrier trenches and drainage work deserve a plan.
How we read it with you
We treat the annex rating as context and the house as the evidence. On a visit we look at crack patterns, floor levels, drainage and any reports you’ve found, and we explain what they suggest. We work with verified contractors and coordinate with licensed engineers as needed when testing or design is the right next step. If the movement turns out to be settlement or slab-related, our pages on foundation settlement repair and foundation cracks explain the paths forward.
If your house has cracks that come and go, or you’re buying and want a clear read, ask for a Free Quote. We’ll start with what’s in front of us.

